MTB Cleat, Studs & Sole Replacement

Sole replacement system
The SRS sole is completely replaceable. Its four tread panels, at the toe, both sides of the forefoot, and at the heel, are equipped with phillips head screws for easy removal and replacement. The rubber used for the SRS sole has the right density for variable trial terrain. It is toe spike compatible. The sole’s inserts and the screws are available as spare parts.

MTB STUDS

Insert the toe studs as shown in the drawing • The spare part is sold separately.

THREADED CLEAT PLATE
Using a screwdriver push, from the outside, the reinforcement plate up to detach the correspondent part of the innersole • 2) Lift the innersole partially detached from the inside, and remove the reinforcement plate replacing it with a new one.

IMPORTANT!  Cleat plates cannot be replaced on GoreTex Shoe models.

CRANK BROTHERS Egg Beater

1-Place the Sidi spacer (suggested and sold separately as spare part).

2-Place the original Crank Brothers cleat fixing it with the Crank Brothers screws A – M5X12mm

SPD PLATE

Place the SPD plate with the original Sidi screws A – M5X12mm
Please, use the Sidi screws provided inside each box.

LOOK PLATE

Place the Look plate with the original Sidi screws A – M5X12mm

Please, use the Sidi screws provided inside each box.

WARNING! No bicycle shoes or other protective device can completely protect you in all foreseeable or unusual accidents. Riding bicycle might be dangerous. In the event of an upset, collision, or other accident, you may be seriously injured or killed, regardless of the type of protective equipment that you are wearing. Do not expect or depend upon your Sidi cycling shoes or other apparel to prevent or reduce injury in the event of an accident. Under some rare circumstances, the wearing of technical footwear may actually increase your injury. The only way to certainly avoid being injured while riding a bicycle is not to ride.